Simagic Alpha Mini Direct Drive Wheelbase Magnet Positional Sensor Replacement

Written By: Hugo Lai

Comments: 0

Simagic Alpha Mini Direct Drive Wheelbase Magnet Positional Sensor Replacement

Difficulty

Moderate

Steps

Time Required

25 - 35 minutes

Introduction

Use this guide to restore the power loss caused by a misplaced sensor on a Simagic Alpha Mini Direct Drive Wheelbase.

Frequent usage can misalign the positional sensor, reducing its power output, which is further exacerbated by the rotating motors during operation. As a result, the inertia and dampening of the wheelbase can be affected, leading to less than desired hardware performance.

Before beginning, be sure that your Simagic firmware is up to date and FFB (Forced Feedback) settings are correctly calibrated.

Alongside following these instructions, you should refer to this device's user manual to make installation and use quick and convenient while adhering to its safe operation guidelines.

Tools

Step 1

Ensure the power connector is switched OFF before plugging in or unplugging the wheelbase. Leaving it on while plugging or unplugging the power connector could damage your device.
Turn the power off.

Step 2

Disconnect all cables from the wheelbase.

Step 3

Use a 2.5 mm Hex Key to remove the two 10 mm screws that connect the wheelbase to the mounting plate.

Step 4

Lay the wheelbase right side up, ensuring the "Simagic" logo is on top.

Step 5

Rotate the wheelbase 180 degrees so the bolts on the back of the device are facing you.
Use a 2.5mm M3 Hex Key to remove four 4 mm screws.

Step 6

Open the electronics cover.
As you open the electronics cover, be careful not to unplug or tear the wires connecting the cover to the wheelbase.

Step 7

Use a 1.5mm M1 Hex Key two remove two 5 mm screws from the back magnet.

Step 8

Turn the wheel shaft until the Wi-Fi symbol is facing up.
The wheelbase was rotated 180 degrees in this picture. However, if your workspace allows it, leave the device with the back facing you, like in the previous step.

Step 9

Ensure the Wi-Fi symbol located on the front of the wheelbase is facing straight up prior to turning the magnet.
Turn the magnet clockwise until one of the screw holes is facing up and the other screw hole is facing right to realign the positional sensor (magnet).